Versions Compared


  • This line was added.
  • This line was removed.
  • Formatting was changed.


  1. Create a LoopEdge Model by selecting the MQTT plain TCP connection. See Create a Device Model.
    Note that the model's JASON schema includes a remote network parameter.

    No Format
      "mqttHostName": "%MQTT_HOST%",
      "mqttTcpPort": "%MQTT_TCP_PORT%",
      "mqttUserName": "%MQTT_USERNAME%",
      "mqttPassword": "%MQTT_PASSWORD%",
      "mqttClientId": "%MQTT_CLIENT_ID%",
      "mqttReqTopicName": "%MQTT_REQ_TOPIC%",
      "mqttRespTopicName": "%MQTT_RESP_TOPIC%",
      "mqttDataTopicName": "%MQTT_DATA_TOPIC%",
      "remoteNetwork": "%REMOTE_NETWORK%"

  2. From the LoopEdge model, create a LoopEdge Device. See Add a Device from a Model.
  3. In the LoopCloud navigation panel, go to Device Mgmt > Devices to view the newly created device in the list.
  4. In the device's Action list, click Status and select Activate.

    This one-time-only code is valid for only 60 seconds. Be sure to take the following LoopEdge steps immediately.

  5. In the Activation Code pop-up, click the  icon to copy the code to the clipboard.

In LoopEdge

  1. In the LoopEdge navigation panel, go to System > Device Management.
  2. Under Cloud Activation, paste the activation code that is in the clipboard and click Activate.

    Include Page

    A LoopEdge DataHub Cloud Connector automatically gets created, but is disabled by default.

  3. In the navigation panel, go to DataHub.

    Include Page

  4. In the Cloud Connector's Actions list, select Enable.
  5. In the navigation panel, go to System > Remote Access.
    A network card shows the activated network.

Configure a Loop Network for Remote Access to LoopEdge


The following high-level diagram illustrates the basic steps required to configure remote access to LoopEdge. Detailed steps are listed below the diagram.

Image Modified

Steps to Configure LoopEdge Remote Access


  1. Copy the network Node ID.

    This unique ID serves as a token to authorize the Loop platform to join the secure private network. 

In LoopCloud 

  1. In the LoopCloud navigation panel, click Remote.

    Include Page

  2. Click the + icon in the upper right of the window to add a member to the network.
  3. In the Add new member dialog, paste the Node ID that you copied from the Loop RemoteAccess service and click Save.

    The node will be listed in the Remote Network list, as part of your network.

  4. At the top of the LoopCloud Remote Network window, click the  icon to copy the network ID.
    You will use this ID in the remote access service to join the network. This establishes the handshake between the private network and the Loop platform.


  1. In the LoopEdge navigation panel, expand System and click Remote Access.
    A network card will be displayed with an IPv6 address.

    Include Page

  2. Select and copy the IPv6 address from the displayed Remote Access network card.
  3. To remotely access the LoopEdge device, enter the IPv6 address enclosed in square brackets into the address/search bar of a web browser.


Image Modified


This IPv6 address is the only address that will be used to remotely access LoopEdge.